I’m up and camp and do not have my code book with me but if I recall correctly at the bottom of C values listed you will see a note for Morison furnaces that 50mm can be used for calculating the mean Diameter. If that isn’t correct I’ll get back to you on Thursday and edit my comment.
What?! you mean you dont read your code book before bed evrynight? haha.
You were right right, the note is just a little under the C values so I must have overloooked it. Thanks again!!
Hey Robbie where do you get the 50mm from for calculating the mean Diameter?
Hey Matt,
I’m up and camp and do not have my code book with me but if I recall correctly at the bottom of C values listed you will see a note for Morison furnaces that 50mm can be used for calculating the mean Diameter. If that isn’t correct I’ll get back to you on Thursday and edit my comment.
What?! you mean you dont read your code book before bed evrynight? haha.
You were right right, the note is just a little under the C values so I must have overloooked it. Thanks again!!